Excursion 2WD V8-5.4L SOHC VIN L (2000)
1. Remove the six retaining bolts.
2. Remove the belly pan.
All vehicles
3. Remove the driveshaft.
4. With a suitable drain pan properly positioned, remove the (A) extension housing seal, using the (B) Oil Seal Remover and the (C) Impact Slide
Hammer.
5. CAUTION: Do not damage any machined surfaces. Damage may cause the new seal to leak.
Using the (A) Extension Housing Bushing Remover, remove the (B) extension housing bushing.
Installation
All vehicles
1. CAUTION: Prior to installing the extension housing bushing, inspect the extension housing counterbore for burrs. If necessary, remove the burrs
with an oil stone or damage to new bushing may occur.
Align the extension housing bushing in the extension housing so that the slots are in the 2 o'clock and 7 o'clock positions.
2. Note: The extension housing bushing is model-dependent.
