Excursion 2WD V8-5.4L SOHC VIN L (2000)
4. Remove the digital Transmission (TR) sensor.
1. Remove the bolts.
2. Remove the digital transmission range (TR) sensor.
5. Note: A No. 53 drill bit (1/16 inch) can be used instead to remove the manual lever shaft retaining pin.
Remove the manual lever shaft retaining pin.
1. Insert the Lock Nut Pin Remover into the retaining pin.
2. Remove the manual lever shaft retaining pin.
6. CAUTION: Be careful not to damage the manual control lever bore.
Note:
-
The manual control lever and manual control lever shaft are one piece.
-
Use a crescent wrench on the manual control lever or outer flats of manual control lever shaft assembly when removing the inner manual valve
detent lever nut.
