Excursion 4WD V10-6.8L (2002)
Headlamp Bulb: Service and Repair
Aerodynamic Lamps
REMOVAL
WARNING: THE HALOGEN BULB CONTAINS GAS UNDER PRESSURE. THE BULB MAY SHATTER IF THE GLASS ENVELOPE IS
SCRATCHED OR IF THE BULB IS DROPPED. HANDLE THE BULB ONLY BY ITS BASE. AVOID TOUCHING THE GLASS
ENVELOPE.
NOTE: The headlamp bulb should not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended
period of time may effect headlamp bulb performance. Contaminants may enter the headlamp where they can settle on the lens and reflector. Never turn
on the headlamp with the bulb removed from the headlamp.
1. Disconnect the headlamp connector.
NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.
2. Remove the headlamp bulb.
1
Rotate the headlamp bulb retainer counterclockwise one-eighth turn.
2
Remove the headlamp bulb.
INSTALLATION
CAUTION: Bulbs 9004 and 9007 look similar, but are not interchangeable.
1. Install the headlamp bulb.
1
Install the headlamp bulb.
2
Rotate the headlamp bulb retainer clockwise one-eighth turn.
2. Connect the headlamp connector.
