Excursion 4WD V10-6.8L (2002)
2. Remove the safety belt buckle.
1
Use the Seat Belt Bolt Bit to remove the safety belt buckle bolt.
2
Disconnect the safety belt warning indicator switch connector.
3
Remove the safety belt buckle.
NOTE:
^
Driver side shown, passenger side similar.
^
Passenger side safety belt buckle is not equipped with a safety belt warning indicator switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
