Excursion 4WD V10-6.8L (2002)
20. Rotate the valve housing with the Bench Mounted Holding Fixture, and use the Input Shaft Bearing/Seal Tool to remove the bearing and power
steering gear input shaft seal.
21. Remove the valve housing from the Bench Mounted Holding Fixture.
22. Install the steering gear housing in the Bench Mounted Holding Fixture and remove the steering gear sector shaft dust seal from the sector shaft
seal bore.
23. Remove the spacer.
1. Remove the snap ring.
2. Remove the spacer.
24. NOTE: The steering gear sector shaft bearing is not replaceable.
Use the Puller to remove the sector shaft seal.
Assembly
