Excursion 4WD V10-6.8L (2002)
All vehicles
1. Press the ring gear and, if removed, a new anti-lock speed sensor on the differential case.
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to the ring gear bolts.
3. With the pinion depth set and the pinion installed, place the differential case in the rear axle housing.
-
Install a shim on the left side as shown in the illustration.
4. CAUTION: The bearing caps mud be installed in their original locations and portions.
NOTE: Apply pressure toward the left side to make sure the left bearing is seated.
Install the left bearing cap, and loosely install the bearing cap bolts.