Excursion 4WD V10-6.8L VIN S (2000)
3. Remove and discard the sun visor gasket (36500A16).
4. CAUTION: If removing a rear rivet nut, removal of the headliner is necessary.
NOTE: If the hole is out of specification, refer to Specifications. See: Exterior Moulding / Trim/Specifications
If installing a new sun visor retaining screw or rivet nut, grind or drill the screw head and rivet nut flush.
5. Punch the remaining rivet nut through the hole.
6. Install a new rivet nut.
7. NOTE:
-
Installation of a new sun visor gasket is necessary when the sun visor has been removed.
-
Prior to installation, clean the sun visor and roof panel mating surfaces.
-
Be sure to wrap the electrical connector with anti-rattle tape before installing the sun visor.
To install, follow the removal procedure in reverse order.
