Excursion 4WD V10-6.8L VIN S (2000)
contamination.
Remove the rear anti-lock brake sensor.
1
Disconnect the electrical connector.
2
Remove the bolt.
3
Remove the rear anti-lock brake sensor.
Installation
1. CAUTION: Use care not to get dirt in the rear axle housing.
Clean and inspect the rear anti-lock brake sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the magnetized rear anti-lock brake sensor pole piece.
3
Inspect the rear anti-lock brake control O-ring for damage. Replace if necessary.
4
Lightly lubricate the rear anti-lock brake control O-ring with SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or
equivalent meeting Ford specification WSL-M2C192-A.
2. Install the rear anti-lock brake sensor.
1
Note: Do not apply force to the plastic rear anti-lock brake sensor connector.
Position the rear anti-lock brake sensor and install the rear anti-lock brake sensor bolt.
2
Connect the electrical connector.
