Excursion 4WD V10-6.8L VIN S (2000)
Apply a bead of silicone in two places where the engine front cover meets the cylinder head.
^
Use Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4.
2. Position the valve cover and the valve cover gasket on the cylinder head and loosely install the bolts.
3. Tighten the bolts in the sequence shown.
4. Position the fuel charging wiring onto the valve cover studs and connect the fuel pressure regulator vacuum hose.
