Excursion 4WD V10-6.8L VIN S (2000)
19. Install the engine mount nuts.
20. Lower the vehicle.
21. Remove the Modular Engine Support Bracket from the engine.
22. Install the generator.
23. Install the fan shroud.
24. Note: The idle air control valve is shown removed for clarity.
Install the throttle body adapter
^
Position a new throttle body adapter gasket.
^
Position the throttle body adapter.
^
Install four bolts and tighten in two stages.
^
Stage 1: Tighten to 8-10 Nm (71-88 inch lbs.).
^
Stage 2: Tighten an additional 85-95 degrees.
25. Note: The EGR valve is shown removed for clarity.