Excursion 4WD V10-6.8L VIN S (2000)
SuperCab
Safety Belt Bolt Bit
SPECIAL SERVICE TOOL(S)
REMOVAL
NOTE: Safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be replaced separately. However, if a safety belt
assembly was in use during a collision, the belt and retractor must be replaced as well as the center adjust tongue and belt and buckle assembly or the
center adjust tongue and the cable and buckle assembly. When replacing safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues and belts and retractors, use only the replacement parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle
being serviced. Safety belt assemblies must not be interchanged between vehicle models.
1. Remove the shoulder safety belt height adjuster cover push-pin.
2. Remove the shoulder safety belt height adjuster.
1
Position the shoulder safety belt height adjuster cover down.
2
Use the Seat Belt Bolt Bit to remove the shoulder safety belt height adjuster bolt.
3
Remove the shoulder safety belt height adjuster.
3. Remove the front door scuff plate.