Excursion 4WD V10-6.8L VIN S (2000)
Brake Light Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the Brake Pedal Position (BPP) switch electrical connector.
3. Remove the BPP switch.
1
Remove the self-locking pin.
2
Remove the BPP switch from the brake master cylinder push rod.
3
Remove the brake master cylinder push rod spacer.
4
Remove the brake master cylinder push rod bushing.
INSTALLATION
1. To install, reverse the removal procedure.