Excursion 4WD V10-6.8L VIN S (2000)
Connect the ABS sensor harness.
1
Position the ABS sensor harness and install the routing clips.
2
Connect the harness connector.
All vehicles
7. CAUTION: The nonmetallic thrust washer must be installed between the two metal thrust washers. Failure to do so will cause severe
wear to the nonmetallic thrust washer, allowing the axle shaft to travel further in and out during torque thrust causing damage to the
wheel hub and bearing, the axle shaft end seal and the axle shaft.
Install the snap ring.
1
Position the three thrust washers onto the axle shaft.
2
Install the snap ring.
8. Note: Any time the hub lock is removed, a new O-ring seal must be installed. Failure to do so can cause a vacuum leak and toss of four wheel
drive functions.
Install a new O-ring.
9. Install the hub lock.
1
Position the hub lock.
2
Install the retainer ring.
10. Install the brake disc.
11. Perform the wheel-end vacuum leak test.
