Excursion 4WD V10-6.8L VIN S (2000)
Position the driveshaft center yoke on the spider, and using the C-Frame and Screw, press the bearing cups into position.
^
Install the snap rings.
4. Apply Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-B.
5. On the one-piece rear driveshaft, install a new spring.
6. Note: Align the index marks made during disassembly.
Position the remaining spider, the centering flange yoke and the bearing cup.
