Excursion 4WD V10-6.8L VIN S (2000)
Axle Shaft: Specifications
Front
Dana Model 50 (Part # 229) Front Drive Axle
1 of 2
2 of 2
a
Never back off the pinion nut to reduce preload. If preload reduction is necessary, install a new collapsible spacer and pinion nut.
b
Take frequent pinion bearing torque preload readings.
c
For new pinion bearing installation on Dana model 50 and 60 axles, tighten the pinion nut to a rotating torque of 1.7 - 3.4 Nm (15 - 30 inch lbs.)
(217 - 678 Nm [160 - 500 ft. lbs.]).
d
For original pinion bearing installation, the reading must be 0.56 Nm (5 inch lbs.) more than the initial reading taken during the disassembly
procedure.
Dana Model 60 (Part # 248) Front Drive Axle
1 of 2
