Excursion 4WD V10-6.8L VIN S (2000)
Hublock: Service and Repair
Hub lock Assembly
Removal and Installation
1. Remove the hublock.
1. Remove the retainer ring.
2. Pull outward and remove the hublock.
2. To install, reverse the removal procedure.
^
Clean the O-ring contact area as necessary to provide a good O-ring seal. Install a new hublock O-ring seal kit. Apply a coat of Ford High
Temperature 4x4 Front Axle and Wheel Bearing Grease E8TZ-19590-A meeting Ford specification ESA-M1C198 to the O-ring seal and
contact area.
