Excursion 4WD V10-6.8L VIN S (2000)
6. Remove the bolt and the transfer case control lever assembly.
Installation
CAUTION: A breakaway pin, found only on a new transfer case control lever assembly detent plate, holds the lower shifter arm in the 2H detent
position during installation. This ensures correct transfer case gear engagement during transfer case operation. Carry out this procedure only if
installing a new transfer case control lever assembly. If reinstalling the original transfer cast control lever assembly, refer to Transfer Case Shift
Lever-Original Assembly.
1. Verify that the breakaway pin on the detent plate is inserted into the hole in the lower shifter arm.
2. CAUTION: Do not tighten the bolt that attaches the transfer case control lever assembly to the transmission case at this time.
Align the transfer case control lever assembly pivot bolt over the correct mounting hole in the transmission case and start the bolt into the threaded
hole by hand.
1. For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, install the bolt in the
forward (LH) threaded hole in the transmission case.
2. For vehicles with a gasoline engine and automatic transmission, install the bolt in the rearward (RH) threaded hole in the transmission case.
