Excursion 4WD V8-5.4L SOHC VIN L (2001)
1. Lubricate the following with High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A:
-
Dust boots.
-
Caliper pistons.
-
Piston seals.
-
Cylinder bores.
2. Install the caliper pistons.
1
Install the piston seals.
2
Install the dust boots.
3
CAUTION: Be careful not to damage or dislodge the piston seal.
Insert the caliper pistons.
4
Press the caliper pistons into the cylinder bore being careful not to cock the caliper pistons.
3. Install the rear disc brake caliper.
Brake Caliper Anchor Plate
Removal
1. Remove the brake pads.
2. NOTE: Forward-of-axle rear disc brake caliper anchor plates are mounted using stud bolts.
Remove the bolts and the rear disc brake caliper anchor plate.
Installation
