Excursion 4WD V8-5.4L SOHC VIN L (2001)
14. Remove the third row safety belt guide.
1
Peel the safety belt guide cover down to access the bolt.
2
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
3
Remove the safety belt guide.
CAUTION: If the safety belt retractor is to be reused, do not allow the safety belt to be retracted all the way into the retractor. Doing so may
cause the retractor to lock and not release the safety belt.
15. Pull to release the retaining clips and remove the C-pillar trim panel.
16. Remove the pin-type retainers out of the quarter trim panel.
NOTE: Passenger side is shown, driver side is similar.
17. Pull out to release the retaining clips and position the quarter trim panel out enough to disconnect the power point electrical connector.
