Excursion 4WD V8-5.4L SOHC VIN L (2001)
Power Steering Pump: Service and Repair
Power Steering Pump
Removal and Installation
1. Remove the drive belt.
2. Remove the power steering pump pulley.
3. Disconnect the high-pressure and return lines.
4. Remove the bolts and the pump.
5. To install, reverse the removal procedure.
6. NOTE: Although the pump has four mounting bolt holes, only three bolts are used to mount the pump on the engine.
When connecting a fitting with a seal ring, a new ring must be installed.
-
Use the Seal Replacer to install a seal ring over a fitting.
7. Fill and leak check the system.
