Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Follow the removal procedure in reverse order.
Body Support - Number 2 Lower, Excursion
BODY SUPPORT-NUMBER 2 LOWER, EXCURSION
Removal and Installation
NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
The removal and installation of the LH body mount is shown, removal and installation of the RH body mount is similar.
1. Remove the cowl side trim panel.
2. Pull the carpet back.
3. Remove the plug.
4. Remove the bolt and washer. Discard the bolt.
5. Remove the lower body mount.
6. NOTE: No lubricants of any kind are to be used during body insulator installation.
To install, reverse the removal procedure.
Body Support - Number 3 Lower, Excursion
BODY SUPPORT-NUMBER 3 LOWER, EXCURSION
