Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
2.
Inspect the FICM harness for a part number tag. If present, it will be located between two (2) of the fuel injector harness takeouts. See Figure 1.
[NEW] NOTE: The part number on the tag shows the International(R) part number for the FICM harness.
It differs from Ford Motor Company part numbers. The International® part number is a string of numbers that should end in C97. C97
will be larger than the other numbers on the harness tag.
^
If no tag is present, continue with this inspection.
^
If the tag is present but the part number ends in anything but C97, continue with this inspection.
^
If the tag is present and the part number ends in C97, no FICM harness service is required. Reinstall the CAC duct and proceed to
Road Test Procedure in this Attachment IV.
3.
Remove the air filter cartridge, the outlet tube and the clean air tube. See Figure 2.
4.
Disconnect and clamp off the small hose from the passenger side of the degas bottle and plug hole in the bottle. See Figure 2.
5.
Remove the two (2) bolts and position the degas bottle aside. See Figure 2.
6.
Remove the turbocharger intake tube. See Figure 2.
