Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Kit Installation in this Attachment V.
^
If extensive chafing has occurred which has exposed the copper strands, the harness must be replaced. Do not attempt to repair a chafed
harness if these conditions are found. Proceed to FICM Harness Replacement in this Attachment V.
FICM HARNESS PROTECTION KIT INSTALLATION
NOTE:
Based on when the vehicle being serviced was built, it may have some of the protection kit components, such as harness connector covers, already
installed from the factory. Also, the kit includes additional parts such as rubber caps used to protect the harness from contact with studs and extra
convolute that does not require installation. The kit was designed by International® for other service issues.
Install only the kit components necessary to fulfill the requirements of this recall.
1.
Install the harness connector covers onto both FICM injector harness connectors by carefully bending the wires coming out of the connector and
snapping the cover in place. See Figure 5.
