Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Remove the Fuel injector control module (FICM) bolts.
6. CAUTION: Make sure both latches are released before removing the electrical connectors ar connectar damage can occur.
Position out the FICM and disconnect the electrical connectors. Remove the injector driver module
7. CAUTION: Vehicles with a 6.OL diesel, with the engine cold, fill the degas bottle only to the MIN line. The correct fill level on these
vehicles is between the MIN line and 15 mm (0.59 in) below the MIN line. This fill level will allow for coolant expansion. Overfilling the
degas bottle may result in damage to the pressure cap, which can cause the engine to overheat.
To install reverse the removal procedure
