Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Position the generator and install the mounting bolts. Tighten all to 47 Nm (35 lb-ft).
2.
Connect the generator electrical connector, the B+ electrical connector and reposition the rubber boot cover.
3.
Install the drive belt.
4.
NOTE: Using Motorcraft Metal Brake Parts Cleaner PM-4, thoroughly clean the CAC outlet port and turbocharger inlet port of any oil residue or
dirt that would interfere with an air-tight seal.
Install the CAC tube. Tighten the clamps to 12 Nm (9 lb-ft).
5.
Install the CAC tube bracket.
^
Tighten the stud bolts to 25 Nm (18 lb-ft).
^
Tighten the screws to 2 Nm (18 lb-in).
6.
Position and install the cowl wire harness as follows:
^
Tighten the wire harness bolts to 2 Nm (18 lb-in).
^
Position the power steering reservoir and install the bolts. Tighten to 8 Nm (71 lb-in).
^
Install the ground strap and tighten the bolt to 8 Nm (71 lb-in).
^
Install the MAP sensor and tighten the bolts to 5 Nm (44 lb-in).
7.
Connect the battery terminals.
8.
Check OASIS to verify there are no other Field Service Actions applicable to this vehicle prior to releasing the vehicle back to the owner.
9.
Proceed to Road Test Procedure in this Attachment III.
[NEW] ROAD TEST PROCEDURE
Refer to the Road Test Procedure in Emission Recall 05E15. This road test is to be performed only once per vehicle and only after all applicable recall
and service programs have been completed.
Attachment IV - FICM Harness Inspection
