Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
-
Clean and inspect the sealing surface.
5. NOTE: The glow plug sleeve is made of stainless steel. Lubrication of the glow plug sleeve removal tap is necessary, or damage to the tap and
excessive force will be needed to get the tap started.
Thread the glow plug sleeve removal tap into the glow plug sleeve.
6. Install the glow plug sleeve removal tool into the threaded sleeve and tighten. Use a wrench to thread the tool into the sleeve until the sleeve is
extracted.
7. Clean the glow plug bore with a stiff wire brush. Use filtered compressed air to remove the debris from the glow plug recess.
INSTALLATION
1. Verify the glow plug bore is completely clean and dry.
2. Apply Threadlock 262(R) sealant to the glow plug sleeve in two places.
