ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Driver Air Bag Module|Page 10255 > < Driver Air Bag Module|Page 10253
Page 3
background image

-

Align the passenger air bag module door and push in seating the retaining clips.
-

Place six new offset fasteners onto the deployment door.

4. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag module electrical connector.

5. Connect the passenger air bag module electrical connector.
6. Close the glove compartment.
7. Connect the battery ground cable.
8. With the restraint system diagnostic tools still installed at the remaining deployable devices, prove out the supplemental restraint system (SRS).  

See: Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure

9. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

Please refer to the appropriate Component or System to determine location of the front air bag sensors.

The side air bag sensors are located at or near the base of the B-pillar.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

10. Restore the vehicle to operating condition.

1

WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental
restraint system (SRS) deactivation/reactivation procedure.

Reactivate the supplemental restraint system (SRS).

2

WARNING:  The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use.
Failure to remove could result in injury and possible violation of vehicle safety standards.

With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).  See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure

Driver Air Bag Module|Page 10255 > < Driver Air Bag Module|Page 10253