Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR
REMOVAL
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. NOTE: The CMP sensor is located behind the power steering pump.
Disconnect the camshaft position (CMP) sensor electrical connector.
3. Remove the bolt and the CMP sensor.
INSTALLATION
1. NOTE: Apply clean engine oil to the O-ring before installation.
To install, reverse the removal procedure.
