Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
Stabilizer Link: Service and Repair
Front
Stabilizer Bar Link
Removal and Installation
1. Remove the nut, washer, and bolt, and disconnect the stabilizer bar link from the stabilizer bar.
2. Remove the nut.
3. NOTE: The right-hand stabilizer bar link is equipped with a dished washer (heat shield). The washer must be installed during installation of the
stabilizer bar link.
Remove the bolt and the stabilizer bar link.
4. To install, reverse the removal procedure.
