Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
6. Remove the axle shaft thrust washers.
1
Remove the snap ring.
2
Remove the three thrust washers.
Vehicles equipped with ABS
7. CAUTION: Do not remove the ABS sensor from the bearing.
Disconnect the ABS wheel sensor harness.
1
Disconnect the connector.
2
Disconnect the harness routing clips.
All vehicles
8. NOTE: The wheel hub and bearing is a slip fit design and should not require a puller to remove it.
Remove the wheel hub and bearing.
1
Remove the four lock nuts.
2
Remove the wheel hub and bearing.
