Excursion 4WD V8-6.0L DSL Turbo VIN P (2004)
d)
Switch the flusher pump on and allow it to run for 15 minutes.
e)
Turn the switch off after 15 minutes, then reverse the flusher lines.
f)
Switch the flusher pump on and allow it to run for 15 minutes.
g)
Disconnect the flusher pressure line and blow air through the line until the fluid is drained back into the flusher.
h)
Disconnect the flusher return line.
6.
Remove the remote filter housing and make sure the small bypass orifice is free of foreign material.
7.
Clean the filter magnet and reinstall it along with a new filter.
8.
Install the remote filter housing.
Tighten it to 25 Nm (18 lb-ft).
9.
Install a new in-line filter or install an in-line filter kit. Refer to Section 307-01B of the 2004 F-SD/Excursion Workshop Manual or 307-01C of
the 2004 E-Series workshop Manual for repair instructions.
