Excursion 4WD V8-7.3L DSL Turbo VIN F (2000)
11. Install the 2-Jaw Puller and loosen the rear hub to the point of removal.
12. CAUTION: Do not drop the outer hub bearing when removing the hub.
Remove the rear hub assembly.
13. CAUTION: Install a new hub seal each time the hub assembly is removed.
Note: The inner bearing is located behind the hub seal.
Pack each bearing and replace the hub seals.
14. CAUTION: Use extreme care not to scratch or gouge the seal or bearing surfaces.
If after hub removal, the hub seal or seal inner sleeve remains on the spindle, remove it as shown using the Step Plate and the 2-Jaw Puller.
