EXP L4-098 1.6L VIN 2 2-bbl (1983)
can be replaced.
14.
Inspect distributor base casting for cracks and wear. If base is cracked or worn, replace complete distributor.
15.
Assemble stator retainer to stator. Position retainer so horseshoe opening of retainer is at the vacuum advance diaphragm rod pivot point.
16.
Install stator assembly in distributor base with vacuum advance diaphragm pivot point positioned approximately in front of diaphragm mounting
hole.
17.
Install stator securing screws, ensure stator is free to rotate. If not, disassemble and check parts. Install wire connector securing screws.
18.
Position module connector on top of three pins and press down to seat the connector.
19.
Lightly lubricate distributor shaft and install. Do not over lubricate.
20.
Reverse steps 1 through 4 to complete assembly.
