EXP L4-098 1.6L VIN 4 2-bbl (1982)
connector to ground. If motor runs, check switch ground. If ground is satisfactory, replace coolant temperature switch. If motor does not run,
proceed to step 4.
4.
Using an ohmmeter, check continuity of wire 197 from temperature switch to fan relay. If no continuity exists, check circuit 197 for opens. If
continuity exists, connect a jumper wire from coolant temperature switch connector to ground and proceed to step 5.
5.
Disconnect fan relay wire connector then, connect a jumper wire from wire terminal 37 to 228. If motor runs, replace fan relay. If motor does not
run, check circuit 37 for opens.
