EXP L4-098 1.6L VIN 4 2-bbl (1982)
filter. Install a straight connector (part number 383003-S) and vacuum cap (part number 382444-S) into the end of the removed vacuum connector.
3.
Disconnect the vacuum line leading from the combination air bypass and air control valve (ACV) to the pink/white vacuum retard delay valve
(VRDV) at the pink side of the valve. Install a 5-inch piece of 5/32-inch vacuum hose (part number D0PZ-12226-B) between the pink side of the
vacuum retard delay valve (VRDV) and the air bypass valve.
4.
Disconnect the vacuum line from the distributor. Install a 3-way vacuum tee (part number 373846-S) and a 3-inch piece of 5 /32-inch vacuum hose
(part number D0PZ-12226-B) to the distributor. Reinstall the disconnected vacuum line to the open end of the 3-way tee opposite the distributor.
5.
Connect the open end of the vacuum line that was removed from the pink side of the pink/white vacuum retard delay valve (VRDV) (Step #3) to
the open port of the 3-way vacuum tee that was installed in Step #4.
6.
Refer to Exhibit IV (Page 12). Affix a new Vehicle Emission Control Information (VECI) decal over the existing decal. Verify that the vehicle
identification number (VIN) of the decal matches that of the vehicle.
Exhibit V - Emissions Recall 86E51
7.
Refer to Exhibit V. Prepare an Authorized Modifications decal (Form FPS-8262) as shown. Affix the decal to a flat clean surface on the radiator
support.
Vehicle Emission Control Information (VECI) (Exhibit IV)