EXP L4-098 1.6L VIN 4 2-bbl (1982)
Suspension Spring ( Coil / Leaf ): Service and Repair
Removal
1. Raise vehicle on a hoist and place a floor jack under lower control arm. Raise lower control arm to curb position.
NOTE: If a twin hoist is used, vehicle must be supported on jack stands placed under jack pads of the underbody FORWARD of the tie rod
bracket.
2. Remove tire and wheel assembly.
3. Remove nut, bolt, and washer retaining the lower control arm to the spindle.
4. Slowly lower control arm with floor jack until spring can be removed.
Installation
1. The spring insulator must be replaced when servicing spring.