EXP L4-98 1.6L SOHC Turbo VIN 8 FI (1984)
Harmonic Balancer - Crankshaft Pulley: Customer Interest
Crankshaft Pulley - Rattle/Squeal Noise
Article No. 84-24-5
NOISE - RATTLE OR SQUEAL - CRANKSHAFT PULLEY LOOSE OR BROKEN - 1.6L
FORD 1983-84 ESCORT, EXP
LINCOLN-MERCURY 1983-84 LYNX, LN7
Rattle or squeal noise may be caused by the crankshaft pulley being loose or broken at the periphery of the attaching bolt opening. This condition is due
to loss of torque at the attaching bolt causing the pulley to be loose.
1.
Remove the crankshaft pulley, washer, and attaching bolt.
FIGURE 3
2.
Discard any attaching bolt identified with a large "C" and a small "H" stamped on the head of the bolt (Figure 3).
3.
Replace the pulley if found broken (Part No. E2FZ- 6A312-A).
4.
Install pulley, washer, and new pulley attaching bolt (Part No. E1FZ-6A340-A), identified with an "M"
stamped on the head of the bolt using the following procedure:
^
Hold the crankshaft pulley stationary using crankshaft bolt wrench YA-826 or equivalent, and tighten the pulley attaching bolt 110-132 N-m
(81-98 ft. lbs.) using crankshaft pulley wrench T81P-6312-A.
5.
Install the accessory drive belts and tighten to specification as outlined in Section 27-02-6 of the 1984 Car Shop Manual E.
PART NUMBER
PART NAME
CLASS
E2FZ-6A312-A
Pulley - Crankshaft
BM
E1FZ-6A340-A
Bolt - Pulley
RM
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: 6316A
TIME:
0.7 Hr. DLR. CODING: Basic Part No. 6A340 Code: 33
