Expedition 2WD V8-281 4.6L VIN W EFI (1997)
Brake Pedal Assy: Service and Repair
Disconnect Brake Master Cylinder Push Rod
REMOVAL
1. Disconnect the brake master cylinder push rod.
a. Remove the self-locking pin.
b. Separate the (A) brake on off (BOO) switch from the (B) brake master cylinder push rod.
c. Remove the brake master cylinder push rod spacer.
d. Remove the brake master cylinder push rod bushing.
Remove Brake Pedal Assembly
2. Remove the one brake pedal bracket bolt and the four brake pedal bracket nuts and remove the brake pedal assembly.
CAUTION: Support the brake master cylinder and power brake booster in the engine compartment.
Install Brake Pedal Assembly
INSTALLATION
To install, reverse the removal procedure, noting the following:
^
Tighten pedal nuts and bolt to 22-28 Nm (17-20 ft. lbs.).