Expedition 2WD V8-281 4.6L VIN W EFI (1997)
a. Remove the bolts.
b. Lift the rear disc brake caliper off the rear disc brake caliper anchor plate.
CAUTION: Do not remove the caliper guide pins or caliper guide pin boots unless a problem is suspected. The caliper guide pins are meant to be
sealed for life and are not repairable. At the time of publication there are no approved materials or procedures to lubricate the caliper guide pins.
Other greases may swell the caliper guide pin boots resulting in contamination and accelerated corrosion or wear of the caliper guide pin
mechanism.
7. Inspect the rear disc brake caliper for leaks.
^
If leaks are found, disassembly is required.
Measure Rear Disc Brake Rotor Thickness
8. Measure the rear disc brake rotor thickness.
^
Replace the rear disc brake rotor if not within specification.
Install Rear Disc Brake Caliper
INSTALLATION
1. Install the front disc brake caliper and bolts; torque to 27 Nm (20 ft. lbs.).
CAUTION: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
NOTE:
^
Make sure the stainless steel shoe slippers are correctly positioned. Replace if worn or damaged.
^
Make sure the notches on the upper ends of the brake shoe and linings are seated over the upper shoe slipper.
