Expedition 2WD V8-281 4.6L VIN W EFI (1997)
Parking Brake Cable: Service and Repair
Front
REMOVAL
1. Remove parking brake control.
Disconnect Front Parking Brake Cable From RH Parking Brake Rear Cable And Conduit
2. Disconnect the (A) front parking brake cable from the (B) RH parking brake rear cable and conduit.
3. Remove the front parking brake cable and conduit.
a. Pry the rubber seal from the front floor pan.
b. Compress the retainer and release the front parking brake cable and conduit from the bracket.
c. Remove the front parking brake cable and
INSTALLATION
To install, reverse the removal procedure, noting the following:
^
Tighten mounting bolts to 15-20 Nm (11-15 ft. lbs.).
