Expedition 2WD V8-281 4.6L VIN W EFI (1997)
3. Remove the steering wheel bolt.
4. Use (A) 2-Jaw Puller to remove the steering wheel.
CAUTION: Removing the steering wheel without using a puller can damage the column bearings.
INSTALLATION
1. Install the steering wheel.
(1) Position the steering wheel.
(2) Install the bolt.
2. Install the driver side air bag module.
(1) Connect the air bag sliding contact electrical connector.
(2) Connect the horn electrical connector.
(3) Position the driver side air bag module.
(4) Install the two screws.
3. Connect the battery cables.
(1) Connect the battery to starter relay cable.
(2) Connect the battery ground cable.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
