Expedition 2WD V8-281 4.6L VIN W EFI (1997)
^
Install two reinforcing plates, bolts and nuts on rear flange of track bar bracket: one on outside of bracket and one inside of crossmember.
Tighten to 81.4 Nm (60 lb/ft) and spray with Super Seal Anti-Corrosion Compound or equivalent. See Figure 10.
^
Repeat step 17 on front flange of track bar bracket.
18.
On vehicles equipped with air suspension, install left rear air spring as follows:
^
Position air spring in its mountings.
^
Install air spring upper and lower retaining clips.
^
Connect air spring electrical connector.
^
Connect air spring air line.
19.
On vehicles equipped with coil spring suspension, install left rear coil spring as follows:
^
Install coil spring in its mountings.
^
Raise jack to position rear axle in its installed position.
^
Position sway bar on sway bar links, then install retaining bolts. Tighten to 86-114 Nm (65-85 lb/ft).
^
Position both rear shock absorbers on their mounting brackets, then install both lower retaining bolts. Tighten bolts to 86-114 Nm (65-85
lb/ft).
^
Remove hydraulic jack.
20.
Position EVAP canister on left frame rail, then install retaining nuts.
21.
Connect EVAP canister electrical connector.
22.
Unplug and connect canister vapor line.