Expedition 2WD V8-281 4.6L VIN W EFI (1997)
Stabilizer Link: Customer Interest
Rear Sway Bar Link - Clunking/Rattling Noise
Article No.
97-26-25
12/22/97
NOISE - "CLUNKING/RATTLING" NOISE COMING
FROM REAR OF VEHICLE - VEHICLES BUILT
THROUGH 4/11/97
LIGHT TRUCK:
1997 EXPEDITION
ISSUE:
A "clunking/rattling" noise may be heard from the rear of the vehicle when going over bumps. This may be caused by a bushing falling out of the rear
sway bar link.
ACTION:
Replace the sway bar ink and install a washer onto the sway bar link. The washer should reduce the possibility of the bushing coming off of the sway bar
link. Refer to the following Service Procedure for details.
SERVICE PROCEDURE
1.
Replace the rear Sway Bar Link (F75Z-5K484-AA) and install a Washer (N800916-S100) on the end of the bolt that holds the link to the frame.
Refer to the 1998 Expedition Workshop Manual for correct replacement procedures.
2.
Torque the bolt to 103 N.m (76 lb-ft).
3.
Repeat this for the opposite side of the vehicle.
PART NUMBER
PART NAME
F75Z-5K484-AA
Sway Bar Link
N800916-S100
Washer
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
972625AT
Replace Link And Washer
0.5 Hr.
- Both Sides
972625A
Replace Link And Washer
0.4 Hr.
- One Side
DEALER CODING
CONDITION
BASIC PART NO.
CODE
5K484
12
OASIS CODES: 303000, 304000, 305000, 702200, 702300