Expedition 2WD V8-4.6L SOHC VIN W (2000)
Multifunction Electronic Control Modules: Service and Repair
Module-Generic Electronic (GEM)
REMOVAL
1. Disconnect the battery ground cable.
CAUTION:
^
Prior to removal of the module, it is necessary to upload module configuration information to scan tool. This information needs to be
downloaded into the new module once installed. For additional information, refer to Module Communications Network.
^
Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.
2. Remove the steering column cover. For additional information, refer to Dash Board.
3. Remove the (A) bulkhead electrical connectors from the (B) instrument panel fuse junction panel.
4. Remove the (A) instrument panel fuse junction panel bolts and remove the (B) interior fuse junction panel nuts.
5. Disconnect the (A) Generic Electronic Module (GEM) electrical connectors from the (B) GEM.
