Expedition 2WD V8-4.6L SOHC VIN W (2000)
Installation
1. CAUTION: Make sure that the notches on the case flange and anti-lock speed sensor ring are aligned.
Press the ring gear and, if removed, a new anti-lock speed sensor on the differential case.
2. Install the ring gear bolts.
-
Apply Stud and Bearing Mount E0AZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to the ring gear bolts.
3. With pinion depth set and the pinion installed, place the differential case in the rear axle housing.
4. Install a (nominal) shim on the left side.
5. CAUTION: The bearing caps must be installed in their identical locations and positions.
Note: Apply pressure toward the left side to make sure the left bearing cap is seated.
