Expedition 2WD V8-5.4L (2009)
-
Apply the specified lubricant to the inside of the guide pin bushings.
-
Install the guide pin bushings into the caliper bores.
-
Install the guide pin into the bushings.
3. Install the inboard brake pad onto the caliper.
4. Rotate the outer brake pad upper and lower retaining springs 90 degrees.
5. Remove the protective paper from the outboard brake pad and install it onto the brake caliper.
6. NOTE: Make sure that the inner brake pad retaining springs are correctly seated onto the brake caliper anchor plate.
Position the brake caliper assembly onto the anchor plate.
7. Install the 2 brake caliper guide pin bolts and the 2 bushing caps.
-
Tighten the bolts to 55 Nm (41 lb-ft).
8. Rotate the outer brake pad upper and lower retaining springs until they are correctly seated in the machined slot on the anchor plate.
9. Install the anchor housing spring using the following procedure:
1. Insert the tab of the spring into the brake caliper cavity.
2. Twist the tab into the cavity.
