2009 Expedition 2WD V8-54L Steering Gear Service and Repair
3. Release the lower cooling fan shroud position tab and rotate the shroud upwards until the lower tab locks into position.
4. NOTICE: New O-ring seals must be installed any time the lines are disconnected from the steering gear or a leak may occur.
Remove the steering gear turn tubes clamp plate bolt.
-
Discard the O-ring seals.
-
To install, tighten to 11 Nm (97 lb-in).
5. NOTICE: Inspect the banjo bolt damper seals for wear or damage and install new seals as necessary.
Remove the 2 banjo bolt dampers and the steering gear turn tubes.
-
To install, tighten to 33 Nm (24 lb-ft).
6. To install, reverse the removal procedure.
7. Fill the power steering system.
