Expedition 2WD V8-5.4L SOHC VIN L (1997)
1.
Remove the door inner sail panel by pulling the top of the panel to release the upper retention. Then rock the sail panel side-to-side along the door
trim panel to release the panel from its lower mounting in the top of the door trim panel.
2.
Roll the window down and pull back the flocking on the interior side of the run at the bend.
3.
Install butyl (or equivalent) between the run and the edge of the door sheet metal. Best results can be achieved by rolling the butyl into a 6 mm
(0.25") rope about 63 mm (2.5") long before installing.
4.
Press flocking back into place and reinstall sail panel by installing the two lower pins and seating both sides and locate and seat the top pin in the
sail panel.
5.
Road test the vehicle.
OTHER APPLICABLE ARTICLES: NONE
