ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

General Module|Testing and Inspection > < Diagram Information and Instructions|Page 52
Page 2
background image

ACC, or START signals present.

Wiper/Washer Control and Interval Timer 

Front Wipers 

There are four modes of operation for the front wipers: speed dependent interval, slow, fast, and wash. These modes are only active with the
ignition switch in the RUN or ACC position. Speed dependent wipers compensate for the extra moisture that accumulates on the windshield at
higher speeds. At higher speeds, the speed dependent feature shortens the delay between wipes when using the variable interval wiper feature.
Delays will automatically adjust at speeds between 16 and 105 kph (10 and 65 mph).

Rear Wiper

There are two modes of operation for the rear wipers, internal and wash. These modes are only active with the ignition switch in the RUN or
ACC positions and both the liftgate and liftgate glass are closed.

Chime Warning

There are five warning chimes and lamps the Generic Electronic Module (GEM) controls: Headlights operating without the ignition ON (chime
only), door ajar (chime and lamp), key in the ignition (chime only), driver seat belt warning (chime and lamp), and low washer fluid warning
(chime and lamp).

Battery Saver 

The battery saver feature removes extended interior lamp power drains from the battery. The Generic Electronic Module (GEM) will keep power
available for all interior lights and under hood lamp circuits for 40 minutes after the ignition switch is turned OFF. The battery saver timer is reset
by unlocking doors with remote entry key fob, activating a door ajar switch, or changing the ignition to RUN or ACC position. If asleep, the GEM
will wake-up when:
^

Any door becomes ajar or is closed.

^

The key is inserted or removed.

^

The ignition switch is turned to ACC or RUN.

^

The doors are unlocked with the remote entry key fob.

Courtesy Lamps/Illuminated Entry 

The Generic Electronic Module (GEM) illuminates the interior courtesy lamps when any door is ajar. The GEM also provides illuminated entry
when the unlock button is used to unlock the vehicle. All interior courtesy lamps are turned OFF when any of the following occurs:
^

Twenty-five seconds have elapsed since the illuminated entry feature was activated and no door is ajar.

^

The ignition switch is turned to RUN and no door is ajar.

^

Vehicle speed is over 15 mph (a new ajar signal will turn on courtesy lamps only if the vehicle speed is less than 10 mph).

^

A power door lock command is received from the remote entry key fob and no door is ajar.

Running Board Lamps 

The GEM illuminates the running board lamps when the interior lamps are activated and the ignition switch is not in the RUN position.

Delayed Accessory (GEM only) 

The delayed accessory feature provides power to the power windows for ten minutes after the ignition switch is moved from the RUN to OFF
position. If during this ten-minute period either front door is opened, the delayed accessory relay will be de-energized.

One-Touch Window

The power switch for the driver window control has two detents for the down window control. With the ignition switch in RUN or ACC, pressing
the first detent (normal mode) allows manual down window control; pressing harder to the second detent (auto) will cause the driver window to
automatically move to the full down position. Pressing either the up or down window switch will cancel an auto mode operation in progress.

General Module|Testing and Inspection > < Diagram Information and Instructions|Page 52