Expedition 2WD V8-5.4L SOHC VIN L (1997)
Differential Cover: Service and Repair
8.8 Inch Ring Gear
REMOVAL
1. Raise and support the vehicle.
WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so may result
in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
2. Remove the axle housing cover.
(1) Loosen the bolts and drain the lubricant.
(2) Remove the bolts.
(3) Remove the axle housing cover.
INSTALLATION
1. Clean the gasket mating surface of the rear axle and the axle housing cover.
CAUTION: Make sure the machined surfaces on both the axle housing and the axle housing cover are clean and free of oil before installing the
new silicone sealant. The inside of the rear axle must be covered when cleaning the machined surface to prevent contamination.
2. Apply a new, continuous bead of sealant to the axle housing cover.
-
Use Silicone Rubber (Black) F4AZ-19562-B or equivalent meeting Ford specification WSE-M4G323-A1.
3. Install the axle housing cover.
(1) Install the axle housing cover.
(2) Install the bolts.